Loading ...
Loading ...
Loading ...
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2410/SNT2410-FC36
REPLACING THE SCRAPER BAR
(Fig. 16)
Required tool (not included):
◾
one 15 mm socket wrench
◾
one 8 mm open-end wrench or
adjustable wrench
1. Remove the battery pack(s).
2. Lay the snow blower on its side or any
other convenient position for scraper bar
service.
3. Loosen but do not remove the nut on
each skid shoe.
4. Loosen and remove the five nuts on the bottom of the deck, as well as the five bolts
inside.
5. Rotate the connecting plates to completely remove the scraper bar.
6. Replace the worn scraper bar with a new one.
7. Rotate the connecting plates until the holes in the connecting plates, the bottom of
the deck, and the scraper bar are aligned.
8. Reassemble the five bolts and nuts. Securely tighten them.
9. Securely tighten the nut on each skid shoe.
REPLACING THE SHEAR PIN
(Fig. 17)
The shear pins are located in the auger
shaft. They aid in absorbing the instant-
stall torque when the auger strikes
obstacles during work and protect the
gearbox and motor from damage.
Replace the shear pins if they are broken
(Fig. 17a).
a
b
b
d
c
16
Scraper Bar
Nut on the skid shoe
Bottom of deck
Connecting Plate
Screw
Nut
17a
Auger Shaft
Shear Pins & Nuts
Loading ...
Loading ...
Loading ...