Loading ...
Loading ...
Loading ...
8 se c t i O n 3— as s e M b l y & se t -up
C.
beam bracket and release the beam lock. See Fig 3-3.
Fasten the tongue tube to the frame by reinstalling the two D.
three-inch hex screws removed earlier and tightly securing
with the two flange lock nuts. See Fig. 3-3.
Positioning the Jack Stand
Do not attempt to move the logsplitter
off of the crate base until after the jack stand has
been positioned downward.
The jack stand is shipped in the transport position. It must be
repositioned prior to fully uncrating the logsplitter.
Remove the spring clip and clevis pin and pivot the jack
stand toward the ground, into the operating position.
Secure the jack stand in position with the clevis pin and the 2.
Carefully pry the small block of wood from the base of the 3.
crate and position it beneath the jack stand. See Fig. 3-5.
Removing the Supports
Do not attempt to move the logsplitter
off of the crate base until after the crate supports
and plastic tie-straps have been removed.
There are three tie-straps securing the logsplitter to the crate,
one on the beam support and one on each side of the reservoir
tank, near each fender. There are also two supports found on the
logsplitter crate, one beneath the engine and one beneath the
beam. Carefully cut and discard each tie-strap and remove and
Note: The jack stand, repositioned in the previous step, will
support the weight of the logsplitter with the supports removed.
Loading ...
Loading ...
Loading ...