Loading ...
Loading ...
Loading ...
OPERATIONS
7
The Power Switch is located at the back of the vacuum. Gently press the Power switch with
your foot to switch the machine on and press again to switch off. For the exact location of
the Power Switch please refer to page 5 of this guide.
Press the handle-release pedal (located on the lower left side of the vacuum)
with your foot to place your vacuum into the cleaning position.
The rotating floor brush on your vacuum can be adjusted to clean several floor surfaces.
Bare Floors - For non-carpeted, indoor surfaces
Lowest Setting - For flat pile carpets
Medium Setting - For short and medium pile carpets
High Setting - For Medium to high pile carpets
Max Setting - For plush pile carpet
For above-floor cleaning, the floor brush will continue to rotate but
is raised off the floor. To prevent carpet damage, do not lean on the
vacuum or let the powerfoot tilt forward.
To avoid personal injury and to prevent the cleaner from falling when
cleaning stairs, always place it at the bottom of the stairs.
For optimal cleaning performance, adjust to the lowest practical setting.
If your cleaner is difficult to push or if the rotating brush is grinding into
the carpet too heavily, adjust to the next higher setting. Always ensure
the machine is in the Upright position before adjusting the height setting.
Before cleaning under low
furniture, check area first for
objects that might harm the unit
or block the vacuum hose.
NOTICE:
CAUTION:
NOTE:
TIP
!
!
!
1. Upright – For storage and above-floor
cleaning with tools
2. Normal Cleaning – Press handle-release
pedal once. Position used for most household
floor cleaning tasks
3. Low Cleaning – Use for reaching under low
furniture such as tables, chairs or beds. Avoid
dropping the handle too low, always ensure
the front Turbo-brush stays in contact with the
surface you are vacuuming
1. Turn height adjustment knob to desired setting:
POWER SWITCH
HANDLE POSITIONS
HEIGHT ADJUSTMENT
https://manual-hub.com/
Loading ...
Loading ...
Loading ...