Loading ...
Loading ...
Loading ...
14
USE THIS TROUBLESHOOTING GUIDE AS A FIRST STEP TO RESOLVE ANY
PROBLEMS YOU MAY BE EXPERIENCING.
Any faults not covered in the below table should be resolved by an authorized
service representative.
Other maintenance or service not included in the manual should be performed
by an authorized service representative.
Thank you for selecting a BENNETT READ product.
TROUBLESHOOTING:
To reduce the risk of electric shock, turn power OFF and disconnect plug
from electrical outlet before performing maintenance or troubleshooting.
WARNING:
!
PROBLEM POSSIBLE CAUSES REMEDIES
Vacuum cleaner
won’t run
1. Power cord not plugged in
2. Damaged power cord
1. Check electrical plug
2. Unplug, check for damage, replace if
necessary
Vacuum cleaner
and tools won’t pick
up dirt
1. Incorrect height adjustment
2. Hose not attached to suction
opening
3. Flex Hose not securely attached
4. Crack or hole in hose
5. Broken or worn drive belt
6. Rotating floor brush bristles worn
7. Rotating floor brush jammed
8. Blockage in vacuum
9. Dirt container full
10. Dirt container not installed
properly
11. Filters are dirty
12. Turbobrush is stuck or
debris is wrapped around
the brush roll
1. Adjust Height Adjustment Control to
correct height
2. Firmly push hose wand into hose
wand base
3. Make sure Flex Hose is snapped into
locked position
4. Check hose and replace if needed
5. Replace drive belt, see page 11 & 12
6. Replace brush
7. Remove brush and clean debris from
brush ends
8. Clear clogs, see page 13
9. Empty dirt container
10. Position correctly and lock in place
11. Check pre-motor and post-motor filters
12. See page 12 for maintaining
Turbobrush
Vacuum cleaner is
difficult to push
1. Incorrect height setting 1. Adjust Height Adjustment Control to
correct height setting
Visible dirt escaping
from cleaner
1. Dirt Container full
2. Filters missing or installed
incorrectly
3. Dirt Container installed
incorrectly
1. Empty Dirt Container
2. Check pre-motor and post-motor
filters for correct installation
3. Remove and re-insert dirt
container correctly
https://manual-hub.com/
Loading ...
Loading ...
Loading ...