Loading ...
Loading ...
Loading ...
13
Low suction or poor pick-up may be due to a clog in the vacuum cleaner.
If you notice a change in the sound of the motor, check for clogs.
1. Unplug the vacuum from electrical outlet
2. Empty Dirt Container
3. Check upper tank for build up or blockages
4. If you notice blockages in the upper tank, remove the inner cyclone
(see section below “Cleaning the upper tank”)
5. Grasp the hose wand and separate it from the hose wand base.
Check for blockages in the base, the wand or in the hose
6. If the clog persists, follow the instructions for “Checking the
rotating floor brush and drive belt” on pages 11 and 12 and
inspect the air passageway for obstructions
1. Remove the lid of the Dirt Tank by twisting the lid to
the “unlock” position. Separate the Dirt Tank and
cyclone assembly
2. Wipe the inside of the upper tank and the cyclone
assembly with a damp cloth moistened with water
or a mild cleaning solution
3. To thoroughly clean the filtration disk and inner cyclone,
turn the entire cyclone assembly upside-down, then turn the
filtration disk anticlockwise to release. Lift the inner cyclone
and filtration disk up to remove
4. The inner cyclone and filtration disk may be washed using
a mild detergent. Be sure it is completely dry before
reassembling or you may damage the unit.
5. Once cleaning is complete, reassemble by aligning
the slots on the inner cyclone with the tabs of the centre
column as shown on the right. Then place the filtration
disk over the centre column and slide it straight down on
the top of the inner cyclone. Line up the tabs with the slots
and turn clockwise to lock
CLEARING CLOGS
CLEANING THE UPPER TANK
2
1
3 4
5
5
https://manual-hub.com/
Loading ...
Loading ...
Loading ...