Loading ...
Loading ...
Loading ...
11
You should check your vacuum cleaner’s rotating floor brush and drive belt regularly for wear
or damage. You should also clean the brush and brush ends of string, hair and carpet fibers.
This type of debris can wrap around the brush and hamper its ability to effectively clean your
carpet. Also remove any debris that has accumulated under the brush cover.
1. Unplug the vacuum from
electrical outlet
2. Place handle in low position
and turn vacuum cleaner over
so bottom side is facing up
3. Remove the five screws marked
on the picture to the right and gently
lift the base cover from the machine
4. Grasp rotating floor brush at both
ends and lift
5. Clean string, hair and other debris
from rotating floor brush, paying
particular attention to brush ends
6. Clean string, hair and other
debris from motor pulley and
drive belt areas
7. Check drive belt carefully
for wear, cuts or stressed areas
8. Check air passageway for
obstructions. Remove debris
from this area
9. Insert front edge of the brush
cover and rotate into place.
Fasten the latches and replace
the five screws
CHECK ROTATING FLOOR BRUSH AND DRIVE BELT
This product is intended for household use only and not for commercial
or industrial use. Vacuuming of dust from products like plaster, concrete
or ashes will damage the motor and void the warranty.
Do not operate cleaner with damp or wet filters
or without all filters in place.
Motor Pulley
Air Passageway
To reduce the risk of injury from moving parts, turn vacuum
cleaner off and disconnect power plug from electrical outlet.
NOTICE:
WARNING:
WARNING:
!
!
!
3
4
https://manual-hub.com/
Loading ...
Loading ...
Loading ...