Loading ...
Loading ...
Loading ...
12
The Pet Turbobrush should be checked regularly for blockages or debris wrapping
around the brush.
1. Unplug the vacuum from electrical outlet
2. Remove rotating floor brush from vacuum
cleaner (Steps 1-4 of check rotating floor
brush and drive belt), remove and discard
old drive belt
3. Place new drive belt over motor pulley and
loop other end over rotating floor brush in
the space between the bristles
4. Pull the rotating floor brush firmly into
position, stretching the drive belt, and
place ends of rotating floor brush down
into the slots on sides as shown. Alignment
of brush ends in slots may be necessary to
fully insert the brush
5. Turn rotating floor brush by hand several
times in the direction of motor pulley. If
properly installed, drive belt will center
itself on rotating brush crown
6. Insert front edge of brush cover and rotate
into place. Snap the front latches in place
and replace the five screws
1. Remove the Pet Turbobrush from hose or
back of vacuum
2. Twist collar anticlockwise to unlock the
top cover. Lift the back end slightly and pull
the top cover backward to release the front
holding pins. Do not use excessive force,
the top cover should slide out easily
3. Remove the brush from the belt and
clean debris
4. Replace the brush inside the belt and
place ends into slots on sides as shown
5. Reposition top cover making sure to line
up inside tabs at the front with the opening
on the cover before closing. Twist collar
clockwise to lock
REPLACE DRIVE BELT
MAINTAINING PET TURBO BRUSH
It is important that you use only genuine Bennett Read replacement belts.
Generic belts may not meet the exact specifications required to keep your
vacuum operating at its peak performance. The use of unbranded belts
could lead to early failure of the vacuum and could void your warranty.
NOTE:
!
Motor Pulley
2
4
https://manual-hub.com/
Loading ...
Loading ...
Loading ...