Loading ...
Loading ...
Loading ...
18
Power Up Functionality :
After power is supplied to the unit :
If no PIN is present the Illuminator will go into Programming Mode for 7
Days and then will default to Operating Mode
-
During this time if the remote is used to change settings the illuminator
will still default into Operating Mode after 7 Days from the power up
(unless the remote disable button is used to change the illuminator to
Operating Mode)
-
During this time if the manual buttons are used in either Illuminator
Settings Modes or Illuminator Configuration Modes the Illuminator will
default into Operating Mode 30 minutes after the last button press
RESET Options :
There are Two Re-set options for resetting your VARIO2 illuminator
Settings Re-set :
Pressing and holding the RESET BUTTON on the remote control or using
the manual buttons to complete a RESET will restore the factory settings
to the illuminator. Note : If a PIN is present it will not be removed and the
illuminator will return to the mode you were in (Programming or
Operating) prior to the re-set command. Both indicator LEDs will flash
AMBER when completed.
Full Re-Set :
The other option to reset your illuminator is available by recycling the
power whilst holding down the two manual buttons. This is a FULL RESET
and will restore factory settings AND remove the PIN if one has been set.
Both Indicator LEDs will flash AMBER when completed.
Loading ...
Loading ...
Loading ...