Loading ...
Loading ...
Loading ...
17
NOTE – If no buttons are pressed within 2 minutes the illuminator times out
and returns to the previous mode it was in – either Programming Mode or
Operating Mode.
Disabling the Manual Buttons :
If the Illuminator is in Operating Mode, once the disable manual buttons
command is executed the buttons will be disabled after 30 minutes. This
is to allow the user to re-enable manual buttons if required.
During this 30 minutes the button response will be the following
-
LHS Button
o
Illuminator Settings Mode cannot be accessed. A momentary
press of the button will not be recognised and the indicator LEDs
will not change
o
Illuminator Security Mode can be accessed in the normal way
by a continuous 4 second press
- RHS Button
o
Pushing this button will cause both indicator LEDS to flash RED
Once the 30 minutes has expired any button push (LHS or RHS) will cause
both indicator LEDs to flash RED and the manual buttons are fully
disabled
Disabling the Manual Buttons Using the Remote :
The manual buttons can be disabled using the remote.
Once the illuminator is put into Operating mode if the disable remote
control Set Up button (see diagram on Page 8) is pressed again and held
for 4 seconds the manual buttons will be disabled. This is shown by both
indicator LEDs flashing RED after 4 seconds.
Note : This command can only be used within 5 minutes of the illuminator
being put into Operating Mode using the Remote Control
(If the Manual Buttons are already Disabled , both LEDs will flash RED
straight away)
Loading ...
Loading ...
Loading ...