Loading ...
Loading ...
Loading ...
10
PIN Function Detail :
The PIN is set by using the Vario Remote Control (VRC). There are five
buttons / characters on the remote that can be used for this purpose.
They are Power 5, Power 1, Min Photocell (Smallest moon), Max Timer (Full
Red Circle) & Timer Disable ( Timer Circle image with a line through) .
Note – invalid characters will not be recognised.
To create a PIN, press STATUS BUTTON for 4 seconds. LHS LED will flash
RED/GREEN. This indication will always show that you are in PIN mode.
RHS LED FLASHING RED shows there you are in PIN set mode. The number
of flashes indicates how many characters are required to complete the
PIN entry. There are four characters to be entered to successfully set up a
PIN.
As you enter the characters, the number of flashes will decrease until all
characters are entered. Note, illegal characters will not be recognised
and will not reduce the number of flashes. When the PIN is set the
illuminator will revert to Programming Mode.
When a PIN is Set :
Using the remote you can access the illuminator settings from operating
mode by entering the PIN.
You cannot access Programming Mode by power re-cycling only.
In operating mode, if you want to go back into programming mode
simply enter your PIN. To do this, press STATUS BUTTON for 4 seconds. LHS
LED will flash RED/GREEN to show you are in PIN mode. RHS LED FLASHING
GREEN shows that a PIN has been previously set. As you input the four
correct characters the number of flashes will reduce and you will be
returned to programming mode.
If legal characters but not the correct sequence of characters is entered
the number of flashes will still reduce and after 4 characters have been
entered an error will be shown by both LED`s flashing RED.
If an illegal character is used when entering a pin, it will be ignored and
the PIN character count will not reduce.
Loading ...
Loading ...
Loading ...