Loading ...
Loading ...
Loading ...
15
For the Installer
6.2 ELECTRICAL CONNECTION TO OPTIONAL WALL CONTROLS
Use the chart below to verify compatibility with the optional controls before making any connection.
Main Controls Auxiliary Controls
S10 ERV PLUS
• Altitude
• Deco-Touch
• Lite-Touch Constructo
• Simple-Touch Constructo
• Constructo
• Dehumidistat
• 20/40/60-minute push-button timer
• 60-minute crank timer
70E+
• Platinum
• Deco-Touch
• Lite-Touch Bronze
• Simple-Touch Bronze
• Bronze
S10 ERV
S10 ERV-R
• Deco-Touch
• Lite-Touch Constructo
• Simple-Touch Constructo
• Constructo
70E ERV
70E ERV-R
• Deco-Touch
• Lite-Touch Bronze
• Simple-Touch Bronze
• Bronze
⚠ WARNING
Always disconnect the unit before making any connections. Failure in disconnecting power could result in electrical
shock or damage of the wall control or electronic module inside the unit.
CAUTION
Never install more than one optional main wall control per unit. Make sure that the wires do not short-circuit
between themselves or by touching any other components on the wall control. Avoid poor wiring connections. To
reduce electrical interference (noise) potential, do not run wall control wiring next to control contactors or near
light dimming circuits, electrical motors, dwelling/building power or lighting wiring, or power distribution panel.
• Use the terminal connector included in the installation kit to perform the electrical connection for main
and optional wall controls.
• Make sure all wires are correctly inserted in their corresponding holes in the terminal block. A wire is
correctly inserted when its orange receptacle is lower than another one without wire. On the picture
below, wire A is correctly inserted, but wire B is not.
• Once the connections have been made, open the unit's door and insert the terminal connector in the
electrical compartment. Secure the cable to the unit by running a tie wrap through the bridge on the
electrical compartment cover.
VE0272
A
B
Loading ...
Loading ...
Loading ...