Loading ...
Loading ...
Loading ...
18
WARNING:
NEVER remove nozzles without first turning off the motor, disconnecting from power supply, relieving
the water pressure in the trigger handle, and locking the lock out on the trigger handle. NEVER point the
nozzle at your face or at others. The quick-connect feature contains small springs that could eject the
nozzle with some force. Failure to follow these instructions could result in an eye injury or other serious
personal injury.
To free any foreign materials clogging or restricting the nozzle, blow out or remove debris with a
straightened paper clip or fine needle (not included).
Using a garden hose, flush debris out of nozzle by back flushing (running the water through the
nozzle backwards or from the outside to the inside).
Reconnect the nozzle to the spray wand.
Turn on the water supply and start the motor.
STORING THE PRESSURE WASHER
NOTE: Regular use of pump protector will give you better performance of the unit and increase
the life of the pump. Store in a dry, covered area where the weather can’t damage it. It is important to
store this product in a frost-free area. Always empty water from all hoses, the pump, and the soap tank
before storing.
Make sure the on/off switch is in the OFF position.
Disconnect both the high pressure hose and the garden hose from the pump.
Tilt the unit to allow any remaining water in the pump to drain from the water inlet.
NOTICE:
If the location where your pressure washer is stored will fall below 32°F, the use of a pump protector is
required before storing to prevent freeze damage. Freeze damage will void your warranty.
Store the unit and accessories in an area that does not reach freezing temperatures. Do not store near
furnace or other sources of heat that could dry out the pump seals.
Loading ...
Loading ...
Loading ...