Loading ...
Loading ...
Loading ...
17
MAINTENANCE
WARNING:
Before inspecting, cleaning, or servicing the machine, shut off motor, wait for all moving
parts to stop, disconnect unit from power supply, and pull trigger to release water pressure.
Failure to follow these instructions can result in serious personal injury or property damage.
WARNING:
Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure
to do so could result in objects being thrown into your eyes, resulting in possible serious
injury.
WARNING:
When servicing, use only identical replacement parts. Use of any other parts could create a
hazard or cause product damage.
NOTICE:
Periodically inspect the entire product for damaged, missing, or loose parts such as screws, nuts, bolts,
caps, etc. Tighten securely all fasteners and caps and do not operate this product until all missing or
damaged parts are replaced. Please call customer service or contact an authorized service center for
assistance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil,
grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleumbased products, penetrating oils,
etc., come in contact with plastic parts. Chemicals can damage, weaken, or destroy plastic
which could result in serious personal injury
PUMP LUBRICATION
The pump on this unit is lubricated with a sufficient amount of high grade lubricant for the life of the unit
under normal operating conditions. Therefore, no further lubrication is required.
PUMP MAINTENANCE
Routinely make a visual inspection of the pump. If you notice any leaking of lubricant around the pump
seals, take the pressure washer to an authorized service center for repair. There are no user serviceable
parts to the pressure washer pump. Any attempt to service or alter the pump may damage the pressure
washer and void your product warranty
NOZZLE MAINTENANCE
Excessive pump pressure (a pulsing sensation felt while squeezing
the trigger) may be the result of a clogged or dirty nozzle.
Turn off the pressure washer, disconnect from power supply, and
shut off the water supply. Pull trigger to release water
pressure.
Remove the nozzle from the spray wand.
Loading ...
Loading ...
Loading ...