Loading ...
Loading ...
Loading ...
2 SHA800A QuickGuide
Identification of Normal State of Equipment
After the equipment is started, there will be no alarm information and error
information at the interface under normal conditions. The curve on screen will scan
from left to right freely; if there is a button in the scanning process or is an alarm or
error prompt, the device may be in an abnormal state. You need to view the specific
prompt information. You can try to restart the setting. If the fault information is still in
place, do not use it for testing. Contact the manufacturer or the maintenance
department designated by the manufacturer to carry out maintenance to avoid
sabotage data by fault operations or endanger the personal safety.
Not Operate with Suspected Failures
If you suspect that there is damage to the instrument, please let qualified service
personnel check it.
Avoid Circuit or Wire Components Exposed
Do not touch exposed connectors or components when the power is on.
Do not operate in wet/damp conditions
Do not operate in an explosive atmosphere
Keep the surface of the instrument clean and dry
Not to use the equipment for measurements on mains circuits, not to use the
equipment for measurements on voltage over the voltage range described in
the manual. The maximum additional transient voltage cannot exceed 1300V.
The responsible body or operator should refer to the instruction manual to
preserve the protection afforded by the equipment. If the equipment is used
in a manner not specified by the manufacturer, the protection provided by the
equipment may be impaired.
Any parts of the device and its accessories are not allowed to be changed or
replaced, other than authorized by the manufacturer or agent.
Loading ...
Loading ...
Loading ...