Loading ...
Loading ...
Loading ...
TRUE RESIDENTIAL
®
TEC_TM_155 | REV. D | EN09/23/2022Page 56 of 66
P#829867
MAINTENANCE, CARE & CLEANING
RESTARTING
Use the following instructions to restart your ice
machine after winterization:
1. Install a new water filter in the unit. See "Water
Filter Installation" (page 32).
2. Reconnect the incoming water line and turn on the
water supply.
3. Plug in the unit.
4. Descale the ice machine. See "Descaling"
(page 51).
5. Press power to start ice making.
NOTE: THE FRESH WATER THAT IS
INTRODUCED DURING DESCALING AND START-
UP WILL FLUSH THE PROPYLENE GLYCOL
DOWN THE DRAIN.
WINTERIZING
NOTICE: DO NOT ALLOW THE ICE
MACHINE TO BE EXPOSED TO
TEMPERATURES BELOW 32˚F (0˚C)
WITHOUT WINTERIZING THE UNIT
AS THIS WILL CAUSE ANY WATER IN THE
MACHINE TO FREEZE. FAILURES CAUSED BY
EXPOSURE TO FREEZING TEMPERATURES ARE
NOT COVERED BY THE WARRANTY.
Use the following instructions to prepare your ice
machine for storage or winterization:
1. Descale and sanitize the ice machine. See
"Descaling & Sanitizing" (page 51).
2. Turn off the water supply to the machine.
3. Disconnect the incoming water line from the back
of the unit.
4. Remove and discard the water filter. See "Water
Filter Replacement" step 1 (page 47).
5. Press power until the display shows FiL.
Leave the machine on for 20 seconds, and then
press power to turn the unit off.
6. Drain the evaporator compartment by removing the
pump clean-out cap. See "Pump Clean-out Cap"
(page 55).
7. Pour 1 gallon of propylene glycol (RV antifreeze)
into the bin drain to fill the drain pump.
8. Once the drain pump shuts off and all the
propylene glycol is drained, unplug the unit or turn
off the circuit breaker.
9. Wipe down the interior bin with a dry clean cloth.
10. Re-install the pump clean-out cap.
Loading ...
Loading ...
Loading ...