Loading ...
Loading ...
Loading ...
15” TRUE ICE
®
MACHINE INSTALL GUIDE
TEC_TM_155 | REV. D | EN 09/23/2022
Page 49 of 66
MAINTENANCE, CARE & CLEANING
NOTICE: DO NOT USE ANY STEEL
WOOL, ABRASIVE OR CHLORINE-
BASED PRODUCTS TO CLEAN
STAINLESS STEEL SURFACES.
STAINLESS STEEL OPPONENTS
There are three basic things which can break down
your stainless steel’s passivity layer and allow corrosion
to rear its ugly head.
• Scratches from wire brushes, scrapers, and steel
pads are just a few examples of items that can be
abrasive to stainless steel’s surface.
• Deposits left on your stainless steel can leave spots.
You may have hard or soft water depending on what
part of the country you live in. Hard water can leave
spots. Hard water that is heated can leave deposits
if left to sit too long. These deposits can cause the
passive layer to break down and rust your stainless
steel. All deposits left from food prep or service
should be removed as soon as possible.
• Chlorides are present in table salt, food, and water.
Household and industrial cleaners are the worst
type of chlorides to use.
STAINLESS STEEL EQUIPMENT CARE AND CLEANING
STAINLESS STEEL CLEANING AND
RESTORATION
Do not use stainless steel cleaners or similar solvents
to clean plastic or powder-coated parts. Instead, use
warm soapy water.
• For routine cleaning and removal of grease and
oil, apply white vinegar, ammonia, or any good
commercial detergent* with a soft cloth or sponge.
• Stainless steel polish (i.e., Zep
®
Stainless Steel
Polish, Weiman
®
Stainless Steel Cleaner & Polish,
Nyco
®
Stainless Steel Cleaner & Polish, or Ecolab
®
Ecoshine
®
) and olive oil can act as a barrier against
fingerprints and smears.
• Degreasers* (i.e., Easy-Off
®
Specialty Kitchen
Degreaser or Simple Green
®
Industrial Cleaner &
Degreaser) are excellent for removal of grease, fatty
acids, blood and burnt-on foods on all surfaces.
• For restoration/passivation or removing stubborn
stains and discoloration, Brillo
®
Cameo
®
, Zud
®
Cleanser, Ecolab
®
Specifax
™
First Impression
®
Metal Polish, Sheila Shine, or talc can be applied
by rubbing in the direction of the polish lines.
* Do not use detergents or degreasers with chlorides
or phosphates.
NOTE: THE USE OF PROPRIETARY NAMES IS
INTENDED FOR EXAMPLE ONLY AND DOES NOT
CONSTITUTE OR IMPLY AN ENDORSEMENT.
OMISSION OF PROPRIETARY CLEANSERS FROM
THIS LIST DOES NOT IMPLY INADEQUACY.
Loading ...
Loading ...
Loading ...