Loading ...
Loading ...
Loading ...
6
ENG
WARNING!
NOTE
Electrical Connection Scheme
Gas Connection
For LPG connection
220-240V~50/60Hz
H05 VV-F 3G 4 mm² H05 VV-F 5G 1.5 mm² H05 VV-F 4G 1.5 mm² H05 VV-F 3G 4 mm²
380-415V 3N~50/60Hz 380-415V 2N~50/60Hz220-240V~50/60Hz
Live
Phase
Neutral Neutral
Neutral
Neutral
Earth Earth
Earth
Earth
Before starting any work related with gas installation, turn off gas supply. Risk of explosion.
Please operate your oven in dry atmosphere.
1. Fit the clamp to the hose. Push one of the hose
until it goes to the end of the pipe.
2. For the sealing control; ensure that the buttons
in the control panel are closed, but the gas
cylinder is open. Apply some soap bubbles to the
connection. If there is gas leakage, there will be
foaming in the soaped area.
3. The oven should be using a well ventilation place
and should be install on flat ground.
4. Re-inspect the gas connection.
5. When placing your oven to its location, ensure
that it is at the counter level. Bring it to the counter
level by adjusting the feet if necessary.
6. Do not make gas hose and electrical cable of
your oven go through theheated areas, especially
through the rear side of the oven. Do not move
gas connected oven. Since the forcing shall loosen
the hose, gas leakage may occur.
7. Please use flexible hose for gas connection.
Main Gas Pipe
Gasket
Hose Inlet Connector
Metal Clamp
LPG Connection Hose
For LPG (cylinder) connection, affix metal clamp on the
hose coming from LPG cylinder. Affix an edge of the
hose on hose inlet connector behind the appliance by
pushing to end through heating the hose in boiled
water. Afterward, bring the clamp towards end section
of the hose and tighten it with screwdriver. The gasket
and hose inlet connector required for connection is as
the picture shown below.
The regulator to be affixed on LPG cylinder should
have 300 mmSS feature.
Loading ...
Loading ...
Loading ...