ILve PWI60MP Operating & Installation Manual

Loading ...

Low Flame Adjustment of Burners

When installing the appliance it is recommended to check that the burner minimum speed (Low Flame

Setting) has been correctly adjusted. If it is necessary to change the type of gas, adjustment of the low

flame setting must be completed by the installer. To adjust the minimum setting for the burners the

following steps must be completed

Minimum flow of valve cooking hob taps

• Switch on the burner and turn the control knob towards the minimum flow position;

• Remove the knob;

• Using a screwdriver, adjust the internal screw until the correct low flame is obtained, the screw is

located just to the right of the shaft see figure 1

• Refit the knob.

Minimum flow of non-valved cooking hob taps

•Switchontheburnerandturnthecontrolknobtowardstheminimumflowposition;

•Removetheknob;

•Insertasmallscrewdriverintotheshaftofthegasvalveandadjusttheinternalscrewuntilthecorrect

low flame is obtained; see figure 2

•Refittheknob.

•Unscrewtheadjustmentscrewtoincreasetheflow,ortightenittoreducetheflow.

•Theadjustmentiscorrectwhenthelowflamemeasuresapproximately3or4mm.

•ForULPGtheadjustmentscrewshouldbeturnedfullyclockwise.

•Makesuretheflamedoesnotgooutwhenchangingquicklyfrommaximumflowandviceversa.

ENSURE THE MINIMUM FLAME WILL NOT BE EXTINGUISHED BY AIR DRAUGHTS

43ILVE Freestanding Operating Manual

Loading ...

ILve PWI60MP 60cm Freestanding Electric Oven/Stove