Loading ...
Loading ...
Loading ...
7
NOTE:
It is most important that this appliance is installed
correctly and that operation is correct before use.
Installation shall comply with local, gas, health and
safety requirements.
This appliance shall be installed with sufficient
ventilation to prevent the occurrence of
unacceptable concentrations of health harmful
substances in the room, the appliance is installed in.
Cobra Series Barbeques are designed to provide
years of satisfactory service and correct installation
is essential to achieve the best performance,
efficiency and trouble-free operation.
This appliance must be installed in accordance with
National installation codes and in addition, in
accordance with relevant National / Local codes
covering gas and fire safety.
Australia / New Zealand:
AS/NZS 5601 - Gas Installations.
United Kingdom:
Gas Safety (Installation and Use) Regulations
1998.
BS6173 - Installation of Catering Appliances.
BS5440 - 1 & 2 Installation Flueing & Ventilation.
Ireland:
IS 820 - Non Domestic Gas Installations.
Installations must be carried out by qualified service
persons only. Failure to install equipment to the
relevant codes and manufacturer’s specifications
shown in this section will void the warranty.
Components having adjustments protected (e.g.
paint sealed) by manufacturer, are only to be
adjusted by an qualified service agent. They are
not to be adjusted by the installation person.
Remove all packaging and transit protection
from the appliance including all protective
plastic coating from the door outer panel and
exterior stainless steel panels.
Check equipment and parts for damage.
Report any damage immediately to the carrier
and distributor.
Report any deficiencies to the distributor who
supplied the appliance.
Check that the available gas supply is correct to
that shown on the rating plate attached to the
inner R/H side, below the grease tray.
If the Legs and Rear Rollers are not fitted, carry out
the procedure below to fit Front Legs and Rear
Rollers.
NOTE:
This appliance is fitted with adjustable feet to
enable the appliance to be positioned securely and
level. This should be carried out on completion of
the gas connection.
1. Remove all loose components from the top of
the appliance.
2. Remove screws securing
transit plates to the front
corners of the transit
pallet.
3. Tilt the appliance onto it’s
back and unscrew the
transit bolts from the front
leg mounting plates.
4. Remove front legs from
carton and screw onto
the front leg mounting
plates.
NOTE:
The front legs are adjustable.
Once the rear rollers are
fitted and the appliance is in
it’s operating position, the
front legs can be adjusted to
level the appliance.
5. Remove rear rollers from
carton and attach to rear
leg ring plate. Secure
with 10mm bolts supplied.
6. Lift appliance back onto it’s legs / rollers.
7. Place the cooktop in its final operating position
and use the adjustable feet to level the
appliance.
8. Refit all items removed at Item 1 above.
Attach with Bolt supplied.
Transit Bolt.
Transit Plate.
Adjustable Foot
Adjustable
Front Leg
Loading ...
Loading ...
Loading ...