Loading ...
Loading ...
Loading ...
the following accessories
Sears may recommend other accessories not listed in
the manual. See your nearest Sears store or Catalog
department for other accessoires.
Donot use any accessory unless you have received and
read complete instructionsfor its use.
[ WARNING: For your own safety, push control knob 'OFF' and remove plug I
I from power source outlet before troubleshooting your scroll saw.
Problem
Breaking Blades
E
Motorwitl not run.
L -
i .
Vibrat_n/Noise
Probable Cause
1. Wrong tension.
2. Over working blade.
3. Wrong blade application.
4. Twisting blade in wood.
5, Using the wrong speed.
1. Defective cord or plug.
2. Defective motor or control
board.
Remedy Suggested
1. Adjust blade tension
2. Reduce feed rate.
3. Use narrow blades for cutting thin wood, wide
blades for thicker wood.
4. Avoid side pressure on blade. Feed work slowly.
5. Use slower speeds for thin blades.
1. Replace defective parts before using saw again.
2. Consult Sears Service. Any attempt to repair
this control board or motor may create a HAZARD
unless repair is done by a qualified service
technician. Repair service is available at your
nearest Sears Store.
t. Improper mounting of saw. " t. See mounting instructions in this manual for
NOTE: There wJl!always
prope r mounting technique.
be some v_ration 2. Unsuitable mounting
present when thesaw surface,
is running because of l
reciprocatingblade I :
and arms, 3. Loose table.
: 4. Loose motor mounting.
2. The heavier your work bench is, the less vibration
will occur. A plywood workbench wilt not be as
good as the same size solid lumber. Use
common sense in choosing a mounting surface.
3. Tighten table lock knob.
4. Tighten motor mounting screws.
wiring diagram
WARNING: To avoid electrocution or fire, repair
electrtcals only with recommended service parts,
and reassemble exactly as originally received
when new.
SENSOR
CONNECTION
GREEN
GROUND
LEADS
MOTOR
WHITE
2O
Loading ...
Loading ...
Loading ...