Loading ...
Loading ...
Loading ...
Adjust 90°stop bolt and lower hex nut until head of bolt
rests against underside of table. Lock upper hex nut
against lower hex nut using 13ram wrenches.
TABLE STOP BOL T
HEX NUTS
iiiiiiiii, _ , ,,i,l.lmlll
6. Loosenthe screw holding the bevelscaie pointerand
adjust pointer to 0°, Tighten screw. \
Remember, the bevel scale isa convenicntguide, but
should not be relied upon for precision.
Reassemble the blade support and hold down.
Make trial cuts in scrap wood to determine ff your
angle settings are correct. Adjust the table as re-
quired.
EVEL _CALE POINTER
REMOVING OR REPLACING BLADES
! I
movement, always unplug the saw before Install-
Ing, removing, or replacing the blade.
t. Unplug power cord from outlet.
2. Remove table insert. (Push up from underside of
table.)
3. Release blade tension byturning blade tension knob
counterclockwise.....
!
BLADE TENSION KNOB
4+Insert the blade change rod through the hole above _GE ROD
the blade holder, and loosen the hex socket screw of
the blade holder with the "T" wrench.
5_ Remove blade from upper blade holder.
iii
BLADE TENSION KNOB
"T" WRENCH
11
Loading ...
Loading ...
Loading ...