Loading ...
Loading ...
Loading ...
provided.
3. Remove hold-down by iooseningthe screwtolhe rear
of hold-down foot.
SUPPORT SCREW "--_"
/
/
/
HOLD-DOWN
SCREW
4. Use a small square to check the angle between the
table and the blade. If the space between the square
and the blade is not uniform, the table must be
adjusted,
5. Loosen the bevel lock knob and adjust tabte untilthe
space between the square and theblade isunifo;m.
Tighten the bevel lock knob.
The table should now be approximately 90oto the
blade,
10
Loading ...
Loading ...
Loading ...