Loading ...
Loading ...
Loading ...
assembly and a|ignrnent
6. Loosen the lower blade holder hex socket screw in
INSTALLING PLAIN END BLADES
NOTE: Saw comes set up for plain end blades. If you
are goinglo use pin end blades, refer totheinstructions
under "installing Pin End Blades" below.
1. install the new blade through the insert hole in the
table, and into the lower blade holder. Positionthe
lowerend ofthe blade in the lowerblade holder, atthe
bOttomofthe blade clamp and against the hex socket
screw.
2. Tighten the hex socket screw using the "T" wrench,
while holdingthe blade change rod in position.
-3. Use the same procedure to installthe blade into the
upper blade holder, Before tightening the socket hex
screw,adjust thepositionoftheupper blade holderby
turning the blade tension knob until the end of the
blade is near the top of the blade holder.
4, Remove the "T" wrench and the blade change rod
from the blade holder.
5: Tighten the blade tension k,7ob(clockwise) until the
blade is tensioned.
6. Reinstallthetable insertwith the slottoward the front
ofthe table.
/
"T" WRENCH / _ LOWER
// BLADE CHANGE
BLADE HOLDER
ROD _1
NOTE: TEETH
POINTING DOWNI\\
BLADE CLAMP
\
LOWER BLADE
HOLDER
SC REW
BLADE CHANGE ROD
INSTALLING PIN END BLADES
NOTE_ For pin end blades_the clamp part of the blade
holders needs to be repositioned.
1. Release bladetension byturning blade knobcounter-
clockwise.
2. Use the "T"handle wrench to remove the he×socket
screw and clamp from the upper blade holder. Re-
install the clamp so that the square boss goes into the
recess inthe blade holder and the"V" notches line up.
3. Tighten the hex socket screw,
4. Repeat this procedure on the lower blade holder.
5. install the blade throughthe insert opening. Have the
teeth pointing down. Engagethe pinintothe"V" notch
of the lower blade holder.
6, Pull up on the blade and engage the upper pin in the
notch of the upper blade holder.
7, Follow the tensioning procedure for plain end blades
to comptete the installation.
i i
'V" ,
NOTCHES
SQUARE BOSS SQUARE RECESS
BLADE CLAMP UPPER BLADE HOLDER
ii i i , i i
SQUARE RECESS
SQUARE BOSS
\
BLADE CLAMP LOWER BLADE HOLDER
12
Loading ...
Loading ...
Loading ...