Loading ...
Loading ...
Loading ...
22 10.0AMP PLUNGE ROUTER
CARE AND MAINTENANCE
WARNING: Always disconnect the device before performing any adjustment or
maintenance operation. if the replacement of the supply cord is necessary, this has to be
done by the manufacturer or his agent in order to avoid a safety hazard
Disconnect from the power supply immediately if the supply cord is damaged. Take care
not to expose this tool to the rain.
If the carbon brushes need to be replaced, have this done by a qualified repair person
(always replace the two brushes at the same time)
1. Cleaning
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to
damage from various types of commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, carbon dust, etc.
2. Lubrication
All the bearings in this tool are lubricated with a sufficient amount of high grade lubricant
for the life of the unit under normal operating conditions, therefore no further lubrication is
required.
EXTENSION CORDS
WARNING: If an extension cord is necessary, a cord with adequate size conductors
that is capable of carrying the current necessary for your tool must be used. This will
prevent excessive voltage drop, loss of power or overheating. Grounded tools must use
3-wire extension cords that have 3-prong plugs and receptacles.
NOTICE: The smaller the gauge number, the heavier the cord.
RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT ALTERNATING CURRENT
TOOLS
Tool’s Ampere Rating Cord Size in A.W.G Wire sizes in mm
2
Cord length in feet
25 50 100 150
Cord length in meters
15 30 60 120
3-6
6-8
8-10
10-12
12-16
18 16 16 14
18 16 14 12
18 16 14 12
16 16 14 12
14 12 - -
0.75 0.75 1.5 2.5
0.75 1.0 2.5 4.0
0.75 1.0 2.5 4.0
1.0 2.5 4.0 -
- - - -
Loading ...
Loading ...