Loading ...
Loading ...
Loading ...
10.0AMP PLUNGE ROUTER 11
OPERATING INSTRUCTIONS
1. Installing/removing the router bit
To install the bit
a) Unplug the router.
b) Rotate the chip shield to flat.
c) Place the router upside down on a
smooth, flat surface.
d) Keep the spindle lock button
depressed and rotate the spindle until
the spindle lock fully engages.
e) Loosen the collet nut using the
wrench provided. Insert the shank
of the router bit into the collet
chuck assembly as far as it will go, then back the shank out until the cutters are
approximately 1/8" to 1/4" away from the collet nut face. To ensure proper gripping
of the router bit and minimize run-out, the shank of the router bit must be inserted
at least 5/8".Keep the spindle lock button depressed and use the wrench provided
to tighten the collet nut.
f) Release the spindle lock.
g) Rotate the chip shield back to its original vertical position before operation.
To remove the bit
CAUTION: Burn hazard. The router bits get hot during use. Allow sufficient
time for the bit to cool before replacing it.
a) Keep the spindle lock button depressed.
b) Loosen the collet nut using the wrench provided and remove the bit.
c) Release the spindle lock.
1
Loading ...
Loading ...
Loading ...