Loading ...
Loading ...
Loading ...
10.0AMP PLUNGE ROUTER 19
OPERATING INSTRUCTIONS
b) Direction of Feed- Internal Cuts
When making an internal cut, such as
a groove, dado, or slot, always have the
guide you are using with the router (edge
guide, straight edge, or board guide) on
the right-hand side of the router as you
make the cut.
When the guide is positioned on the
right hand side of the router, the router
travel should be from left to right and
“counterclockwise” around curves (see
figure 10b).
This counterclockwise action around
the curve could cause “Climb cutting”.
Always be alert and exercise extreme
caution to maintain control of the router
when making this type of cut around
curves.
When the guide is positioned as shown
in figure 10c, the router travel should be
from left to right and clockwise around
curves.
If there is a choice, the set-up in figure
10b is easier to use, but there is the
possibility of “Climb Cutting” around
curves. In either case, figure 10b or figure
10c, the sideways thrust of the router cutting is always against the guide, as is proper.
WARNING: Always securely clamp the workpiece in place, and keep a firm grip on
the router base with both hands at all times. Failure to do so could result in loss of control
causing possible serious personal injury.
Bit Rotation
Bit Rotation
Router Feed Direction
Guide
GUIDE INSIDE
Thrust
10c
Bit Rotation
Bit Rotation
Router Feed
Direction
Guide
GUIDE OUTSIDE
Thrust
10b
Loading ...
Loading ...
Loading ...