Loading ...
Loading ...
Loading ...
34 English
Device fuses (overview) A: Fuses on the electronic controller
B: Fuses in the wiring harness (fuse holder)
Device fuse Value (A) Designation
F100H 7.5 Key-operated switch
F102H 7.5 Work light
F103H 7.5 Water pump
F104H 3 LED
F105H 7.5 Work light
F106H 3 Blue spot
F107H 1 Counter
F109H 5 Filter motor
F110H 7.5 Signal horn
F111H 10 Lifting motors
F112H 5 Start the motor
F113H 1 Flashing beacon
F114H 1 Position sensor,
emptying
F200H 30 Main fuse
F201H 3 K1 Main valve
F205H 3 K4 Sweeper units
F207H 3 K6 Open flap
F209H 3 K3 Close flap
F212H 3 K5 Lift
F213H 3 K2 Lower
Device fuse Value (A) Designation
F1 (M9) 7.5 Lifting motor
F2 (M8) 7.5 Lifting motor
F3 (M11) 7.5 Lifting motor
Fault Rectification
Motor will not start Check/charge the starter battery.
Key switch to position “I - ON”.
Programme selector switch to "Drive" position
During cold exterior temperatures: Operate the choke lever.
Sit in the driver's seat (seat contact switch is activated).
Fully close the bonnet and right panel.
Check motor oil level, top up motor oil if necessary.
Fill with fuel.
Open the fuel cock.
Check spark plug.
Motor running irregularly Check the filling level of the fuel tank.
Check the position of the choke lever.
Check connections and lines of fuel system.
Check/clean/replace spark plug.
Clean/replace the air filter.
Engine is running, but the de-
vice does not drive or just
slowly
Release the parking brake.
Check the position of the neutral lever.
Check/top up the filling level of the hydraulic oil tank.
In the event of freezing temperatures and cold hydraulic oil: Allow the device to warm up for at least
3 minutes.
Motor does not switch off
(programme selector switch
and key switch are in the OFF
position)
Petrol engine:
a Open the bonnet (be careful of the rotating V-belt).
b Close the fuel cock.
Dust when sweeping / insuffi-
cient suction power
Empty the waste container.
Check / clean / replace the dust filter.
a Check that the dust filter is firmly in place.
b In case of light soiling, clean the dust filter.
c In case of damage or heavy soiling, replace the dust filter.
Check the sealing strips in the sweeping area to check for wear. Readjust or replace if necessary.
Check/replace the seals on the filter box.
Check/replace sealing strips on waste container.
Loading ...
Loading ...
Loading ...