Loading ...
Loading ...
Loading ...
5.
Oponal: You can set the parameters of mulple areas by repeang the above steps.
6.
For the arming schedule sengs, refer to Set Arming Schedule . For the linkage method sengs,
refer to Linkage Method Sengs .
7.
Click Save.
6.2.7 Set Region Exing Detecon
It is used to detect objects exing from a pre-dened virtual region. If it occurs, the device can take
linkage acons.
Before You Start
Go to VCA → VCA Resource , and select Smart Event.
Steps
1.
Go to VCA → Smart Event → Region Exing Detecon
2.
Check Enable.
3.
Select one Region. For the detecon region sengs, refer to Draw Area .
4.
Set the detecon target, sensivity and the target validity.
Sensivity It stands for the percentage of the body part of an acceptable target that goes
across the pre-dened region. Sensivity = 100 - S1/ST × 100. S1 stands for
the target body part that goes across the pre-dened region. ST stands for the
complete target body. The higher the value of sensivity is, the more easily
the alarm can be triggered.
Detecon
Target
Human and vehicle are available. If the detecon target is not selected, all the
detected targets will be reported, including the human and vehicle.
Target
Validity
If you set a higher validity, the required target features should be more
obvious, and the alarm accuracy would be higher. The target with less obvious
features would be missing.
Network Camera User Manual
45
Loading ...
Loading ...
Loading ...