Loading ...
Loading ...
Loading ...
33
5. Sanitizing Procedure - Final
1) Mix a new batch of the sanitizing solution.
2) Make sure the power switch is in the "OFF" position, the icemaker is unplugged from
the electrical outlet, and the water supply line shut-off valve is closed. Remove the top
panel.
3) Remove the spout spring and open the spout cover.
4) Pour the sanitizing solution over the extruding head until the evaporator assembly and
the reservoir are full and the solution starts to run through the overow hose on the
reservoir.
5) Close the spout cover, then replace the spout spring in its correct position.
6) Allow the icemaker to sit for 10 minutes before operation.
7) Move the control switch to the "ICE" position, then plug the icemaker back in to the
electrical outlet. Move the power switch to the "ON" position. Replace the panels in their
correct positions, then make ice using the solution until the icemaker stops making ice.
8) Remove the front panel. Move the power switch to the "OFF" position. Move the control
switch to the "DRAIN" position, then move the power switch to the "ON" position, then
replace the front panel in its correct position.
9) Allow the water system to drain completely.
10) Remove the front panel. Move the power switch to the "OFF" position. Move the control
switch to the "ICE" position, then move the power switch to the "ON" position, then
replace the front panel in its correct position.
11) Open the icemaker water supply line shut-off valve to supply water to the reservoir.
12) After the gear motor starts, remove the front panel. Move the power switch to the "OFF"
position. Move the control switch to the "DRAIN" position, then move the power switch
to the "ON" position. Replace the front panel in its correct position.
13) Allow the water system to drain completely.
14) Remove the front panel. Move the power switch to the "OFF" position, then move the
control switch to the "ICE" position. Move the power switch to the "ON" position, then
replace the front panel in its correct position.
15) Allow the icemaker to run for 30 minutes, then remove the front panel. Move the power
switch to the "OFF" position, then unplug the icemaker from the electrical outlet.
16) Pour warm water into the dispenser unit/ice storage bin and melt any remaining ice.
Clean the dispenser unit/ice storage bin liner using a neutral cleaner. Rinse thoroughly
after cleaning.
17) Plug the icemaker back in to the electrical outlet. Make sure the control switch is in the
"ICE" position, then move the power switch to the "ON" position to start the automatic
icemaking process.
18) Replace the front panel.
Loading ...
Loading ...
Loading ...