Loading ...
Loading ...
Loading ...
31
10) In bad or severe water conditions, clean the oat switch as described below. Otherwise,
continue to step 11.
a. Remove the oat switch from the reservoir cover.
b. Wipe down the oat switch with the cleaning solution.
c. Rinse the oat switch thoroughly with clean water.
d. Replace the oat switch in its correct position.
11) Wipe down the infrared sensor lens, (located on the bottom of the icemaker) with the
cleaning solution. Next, rinse the cleaning solution off of the infrared sensor lens with a
clean, damp cloth.
Note: If the bottom of the icemaker is not accessible in your application, remove the
thumbscrew securing the infrared sensor housing, then remove the housing from the
base. After cleaning and rinsing the lens, replace the housing in its correct position and
secure it with the thumbscrew.
12) Replace the top panel in its correct position. Move the control switch to the "ICE"
position, plug the appliance back into the electrical outlet, then move the power switch
to the "ON" position. Replace the front panel in its correct position and allow the
appliance to make ice using the solution until the icemaker stops making ice.
13) Remove the front panel. Move the power switch to the "OFF" position, then move
the control switch to the "DRAIN" position. Move the power switch back to the "ON"
position, then replace the front panel in its correct position.
14) Allow the water system to drain completely.
15) Remove the front panel. Move the power switch to the "OFF" position, then move the
control switch to the "ICE" position. Move the power switch to the "ON" position, then
replace the front panel in its correct position.
16) Open the icemaker water supply line shut-off valve to supply water to the reservoir.
17) After the gear motor starts, remove the front panel. Move the power switch to the "OFF"
position. Move the control switch to the "DRAIN" position, then move the power switch
back to the "ON" position. Replace the front panel in its correct position.
18) Allow the water system to drain completely.
Note: If you do not sanitize the unit, go to step 14 in "III.B.5. Sanitizing
Procedure - Final."
19) Remove the front panel. Move the power switch to the "OFF" position, then unplug the
icemaker from the electrical outlet. Close the water supply line shut-off valve.
Loading ...
Loading ...
Loading ...