Loading ...
Loading ...
Loading ...
26
3. Mechanical Backup Bin Control Check
1) Make sure the power switch is in the "OFF" position and that the icemaker is unplugged
from the electrical outlet.
2) If not already removed, remove the front panel, top panel, and control box cover.
3) Remove the spout spring from the spout. See Fig. 12.
4) Plug in the icemaker. Make sure the control switch is in the "ICE" position, then move
the power switch to the "ON" position.
5) 30 seconds after the upper oat switch closes, the control board "GM" LED turns on.
After "GM" LED turns on, press the "SERVICE" button on the control board to bypass
the 5-minute compressor delay. WARNING! Risk of electric shock. Care should be
taken not to touch live terminals.
6) "GM" LED and "COMP" LED are on. Open the spout cover slightly. See Fig. 13.
"GM" LED and "COMP" LED turn off within 10 seconds and the control board sounds a
9 beep alarm. Close the spout cover.
Fig. 12
Spout Spring
Spout Cover
Spout
7) Move the power switch to the "OFF" position, then unplug the appliance from the
electrical outlet. Note: The control board alarm resets when power is turned off.
8) Replace the spout spring in its correct position.
9) Replace the control box cover and top panel in their correct positions.
10) Plug in the icemaker. Make sure the control switch is in the "ICE" position, then move
the power switch to the "ON" position to start the automatic icemaking process.
11) Replace the front panel in its correct position.
Fig. 13
Spout Cover
Spout
Loading ...
Loading ...
Loading ...