Loading ...
Loading ...
Loading ...
6
(inlet humidity reading) is 3% lower than the set humidity.
When you see the "wet controller" icon illuminating while setting up, it typically means
the set humidity level is not 3% lower than the inlet humidity reading. Please make
sure the set humidity value is at least 3% (10% recommended) lower than the inlet
humidity reading.
In Humidistat Mode, if you see "wet controller" icon illuminating after running the
dehumidifier for a while, it means the dehumidifier has got the room humidity down
to the set point and the dehumidifier enters into standby mode.
Defrosting Icon: The dehumidifier begins to defrost when the frost has
accumulated on the interior of the dehumidifier. When the dehumidifier is defrosting,
the fan is running, but the compressor is not, the defrost icon is flashing. The
dehumidifying function will cease until the frost has melted. When defrosting is
complete, the defrosting Icon will disappear and the dehumidifier begins to
dehumidify again automatically.
Note: The frequent defrost process indicates that the room temperature is too cold.
Therefore, if the room temperature is lower than 60°F, please consider adding heat to
promote proper drying.
Fan Icon: The fan icon illuminates when the fan is running.
Water Droplets Icon: The water droplets icon illuminates when the compressor
kicks in, which means the dehumidifier is dehumidifying. When the compressor delays
to start due to the 3-minutes delay system, this icon flickers.
Timer Icon: Timer icon illuminates when the timer function is enabled.
Understand the Control Buttons
ON/OFF Button: Press to turn the dehumidifier ON or OFF.
▲ Button: Press ▲to increase the set-point of humidity level or timer.
▼ Button: Press ▼ to decrease the set-point of humidity level or timer.
Timing/Function Button: Press once to check the settings. Press and hold for 3
Defrost
Loading ...
Loading ...
Loading ...