Loading ...
Loading ...
Loading ...
5.2 CLEAN THE MAIN BRUSH
A. As shown in the following figure, press down the buckle
to take out the protective cover, and take out the rolling brush
upwards.
B. Clean the rolling brush with cleaning tools included in the
accessories.
C. Put one end of rolling brush into the corresponding hole
first.
D. Press the brush cover and fix it with the buckle.
5.3 CLEAN ITS SIDE BRUSHES
Foreign matter such as hair can become tangled in the side
brush, be sure to clean it regularly.
A. Turn the vacuum over, hold it in place and pull the side
brush up to remove it.
B. Remove any hair or other debris, wipe with a damp cloth if
necessary.
C. Reinstall the side brush by aligning the square shaft with
the back of the brush, press down until it clicks.
NOTE
It is recommended to replace side brushes every 3-6 months
to ensure cleaning results.
5.4 CLEAN CASTER
Hair or dust particles tend to be entangled around casters.
Clean the them regularly or as needed.
A. Turn the vacuum over, hold it in place and pull up on the
caster. It may be necessary to use a tool such as a flat head
screw driver to pry the wheel out of place. Be careful not to
damage the caster.
B. Remove any hair or other debris, wipe with a damp cloth if
necessary.
C. Reinstall the caster by pressing it in place until it clicks.
Wheel
Shaft
5.5 CLEAN SENSORS AND
CHARGING ELECTRODES
In order to ensure optimum operating conditions, please clean
sensors and charging electrode regularly, and wipe dust off
them with a soft dry cloth or sweep brush.
Anti-drop sensor
Along-the-wall
side sensor
Built-in
TOF lidar
Front bumper
laser sensor
for obstacle
avoidance
Charging
electrode
22
English
EN
Loading ...
Loading ...
Loading ...