Loading ...
Loading ...
Loading ...
B. Start sweep
•
Press to start the auto sweep mode. Once it is
started, the machine will leave the charging dock, scan
automatically to generate a map, intelligently determine
its sweep route, and divide the space into multiple areas.
The sweep route route will be planned along the wall to
sweep in straight lines back and forth to thoroughly clean
on area at a time.
NOTE
• If the battery level is too low to start sweep, please
charge it first.
• Before sweeping all wires on the ground should be
well organized or damage to articles may occur.
• In the auto sweep mode, by default the machine will
do sweeping twice if the sweep duration is shorter
than 10 minutes.
C. Pause
• When the robot vacuum is operating, press to pause.
Press again to resume sweep. During sweep, press once
to stop the current sweep and press twice to return to the
charging dock automatically.
D. Hibernation
•
When the robot vacuum is operating, press
to pause.
Press
again to resume sweep. During sweep, press
once to stop the current sweep and press twice to
return to the charging dock automatically.
E. Charging
• Auto recharge: After sweep, the white light of the
recharge button
will keep blinking and the machine
will automatically return to the charging dock for
charging.
• Manual recharge:
a. If it is paused, press
to recharge it automatically;
b. When the machine is stuck or cannot find the charging
dock, please manually return it to the charging dock for
charging.
F. Fault
• Please refer to the "Common Faults” section herein or
guidelines in the app for repair when any abnormality
occurs to your robot vacuum in operation and the power
indicator is blinking in red with voice prompts.
NOTE
• If it cannot be repaired after the above operations,
please contact our Service Department for consultation
or repair. Do not disassemble the machine by yourself.
G. Reset Wi-Fi
•
Press
and simultaneously for 3 seconds to reset
your Wi-Fi connection when your router has changed,
you've forgotten the password or your phone is unable to
connect to the machine normally for other reasons. The
Wi-Fi status indicator will be blinking slowly in white.
After the Wi-Fi connection is reset, there will be a voice
prompt. After that, you can reset the Wi-Fi connection as
instructed in this app.
4.2 SWEEP MODES
A. Auto Sweep
•
Auto Sweep is the default mode after startup. Press
to start it. The machine will start off the charging dock,
automatically scan and plan the sweep map and path,
and sweep your rooms. After the task is complete, the
machine will return automatically for recharge. It is fast
and convenient.
B. Sweep at Fixed Point
• After the mode is enabled, the machine will sweep a
rectangular area of 1.5m X 1.5m centered on itself. This
mode is very useful if you have any area with much
dust or debris to clean. After such specific area has
been swept, the machine will automatically return to the
charging dock.
a. Manual startup: Move the machine to the area to be
cleaned, press and hold
for 3 seconds to start it up.
b. Startup using app: Open the app, select Pin n Go, and
follow the instructions.
17
English
EN
Loading ...
Loading ...
Loading ...