Loading ...
Loading ...
Loading ...
NOTE
• You may not be able to start the machine when the
battery is low. Please fully charge it and try again.
• To ensure the service life of the battery, please
charge and discharge at least once every six months.
• To enter the low power standby mode when the
machine is being charged, press and hold
and
for 20 seconds until the power status indicator
goes off. Wi-Fi will be disabled when this mode
is active. Press
to exit the low power standby
mode.
4. Install the app
① Download
Scan the QR code and download and install the mobile
application.
NOTE
If the mobile phone cannot be connected to the robot,
please refer to – “Reset Wi-Fi”.
② Reset Wi-Fi
A. Open the machine top cover to expose the Wi-Fi
indicator.
B. Press and hold
and simultaneously till the voice
prompts "reset Wi-Fi". Wait till the Wi-Fi indicator starts
blinking slowly in white, indicating that the robot vacuum
has entered the network configuration mode.
Wi-Fi indicator:
Wi-Fi indicator:
• Blinking slowly in white: Wait for connection
• Blinking fast in white: Being connected to Wi-Fi
• Normally on in white: Wi-Fi connected
③ Add devices
Open the app and create a new account, click the
"+" icon in the upper right corner of the page.
Perform network configuration operations according to
the internal instructions of the APP.
NOTE
• Only the 2.4GHz band, but not the 5GHz one, is
supported in the Wi-Fi connection.Please switch
to the 2.4GHz band if your Wi-Fi network is dual-
band and try again.
• If the connection between your phone and robot
vacuum fails, you can reset Wi-Fi again and add
it again after entering the network configuration
mode.
• As version upgrade and update may be made,
please follow internal guidelines in the app for
operation.
5.
Start sweep by operating it from the app or pressing
manually.
The machine automatically returns to the charging dock
for charging under the following conditions:
A. The machine has completed sweep;
B. Sweep has not been completed yet but the battery
power level is insufficient; Once the battery is charged to
80%, the machine will resume to complete the remaining
sweep work.
NOTE
Do not move the charging dock during sweep, and
make sure the charging dock is powered on, or the
machine may not be able to return for charging. If
automatic recharge fails, you shall manually connect it
to the charging dock.
4 OPERATING INSTRUCTIONS
4.1 USE OF THE MACHINE
A. Startup/shutdown
• When the machine is connected to the charging dock, it
will start automatically.
• If the machine is not connected to its charging dock, press
and hold
for 3 seconds to start it up. Wait until the
power status indicator turns white and is kept ON.
• If the machine is not connected to its charging dock, press
and hold
for 3 seconds to shut it down.
16
English
EN
Loading ...
Loading ...
Loading ...