Loading ...
Loading ...
Loading ...
⑤ Empty the remaining water in the water tank. Wash the
mopping cloth to avoid mildew and odor.
NOTE
• Please do not use the mopping mode on any carpet.
• It is recommended to wash the mopping cloth after each
mopping.
• When the machine is being charged or idle, please
remove the mop module.
• In order to achieve better mopping results, it is
recommended to sweep your floor three times with the
machine before installing the mop module.
• To avoid damaging your wood floor, please make sure
to take out the mop module immediately after floor
mopping is complete. Or install the charging dock onto
the waterproof pad (optional).
• When mopping is paused or finished, the machine will
automatically cut off water. However, the mopping
cloth remains wet and should not be left in place for
too long but removed in time.
4.5 MAP MANAGEMENT
A. Map your rooms in real time
• Real-time mapping helps you easily understand the sweep
route and environment. After sweep, a floor plan of your
rooms will be generated. Maps will be updated in real
time during each sweep to ensure normal navigation.
Generate a complete floor plan of your rooms:
a. Open room doors so that the machine generates a map
of each room;
b. Remove any object that may block or jam the machine;
c. After generating maps, please do not disassemble or
move the charging dock;
B. Repositioning and map regeneration
• If the location of the machine/charging dock is adjusted
or the surrounding environment changes significantly, the
machine will try repositioning and may regenerate a map
to adapt to the surrounding environment. Details are as
follows:
a. If repositioning is successful, the machine will resume
sweep;
b. If repositioning fails, the machine will regenerate a
map to ensure normal navigation for new sweep;
c. If repositioning fails and virtual boundary information
(restricted area) is available in the original map, the
machine will not start a new sweep to avoid crossing any
restricted area.
NOTE
• Make sure that the machine always starts sweep from
the charging dock.
• Do not move the equipment frequently during sweep.
Otherwise, put the machineback to its home position.
4.6 SYSTEM RESET
• If the machine does not respond after pressing any button
thereon, it is an option to reset the system.
a. Ensure that the machine is not on the charging dock;
b. Press the reset button with a paper clip and the machine
will shut down automatically.
c. Connect the machine to the charging dock or press and
hold the key
for 3 seconds to turn it ON and system
reset will be completed.
20
English
EN
Loading ...
Loading ...
Loading ...