Loading ...
Loading ...
Loading ...
General Care & Cleaning (cont'd)
Removing and Replacing Warmer (Warm & Ready TM) Drawer
Ebctrbal Shock Hazard can occur and result
in serious injury or death, Disconnect appfiance from eUectric
power before cbaning and sen, bing the warmerdrawer,
To Remove Warmer Drawer:
1,
drawer,
2, Open the drawer to the fully opened position,
3, Locate glide lever on each side of drawer, pull up on the left
glide lever and push down on the right glide lever (See Figure 1),
4, Pull the drawer away from the range,
To Replace Warmer (Warm & Ready TM) Drawer:
1, Pull the bearing glides to the front of the chassis glide
(See Figure 2),
2, Align the glide on each side of the drawer with the glide slots on
the range,
3, Push the drawer into the range until levers "click" (approximately
2"), Pull the drawer open again to seat bearing glides into
position, if you do not hear the levers "click" or the bearing
glides do not feel seated remove the drawer and repeat
steps 1 thru 3. This will minimize possible damage to the
bearing glides,
Note The Warmer Drawer will NOT operate while in the"Self-Cban and "Oven
Lockout" modes
Left Glide
Pull up bver
with finger
Pull down lever
with finger
Figure 1
Right Glide
Figure 2
::iiiii_;_il
ΒΈ:121111
Changing the Oven Light
The oven lights will automatically turn ON when the oven door is opened, The
oven lights may also be manually operated by pressing the _ pad,
ON/OFF
The lamp is covered with a glass shield, The glass shield can be removed to be
cleaned manually or to change oven light, THiS GLASS SHIELD MUST BE iN
PLACE WHENEVER THE OVEN iS iN USE,
To replace the light bulb:
CAUTION: BE SURE THE OVEN IS COOL.
1, Turn the power off at the main source,
2, Wear a bather-faced glove for protection against possible broken glass,
3, To remove the glass shield, pull the back side of the shield toward the
inside of the oven in a manner to lift it up from the oven side,
4, The glass shield should come out easily by pushing a little toward front of
the range,
5, Replace halogen light appliance bulb taking care not to touch the bulb with
your bare fingers, Touching bulb with your skin can leave a film on the bulb
that causes it to burn out quickly,
6, Replace glass shield in opposite order and manner of removal,
of glass shield
and remove it.
43
Loading ...
Loading ...
Loading ...