Loading ...
Loading ...
Loading ...
Setting Surface Controls (cont'd)
Operating Single Radiant Surface E_ements
The cooktop has 4 SUNGLE radiant surface eUements: the
RIGHT REAR position (Figure 1), the CENTER REAR position
(Figure 2), the LEFT REAR position (Figure 3) and the LEFT
FRONT position (Figure 4). The UefteUements may be combined
with the bridge eUement. Refer to Page 10 for recommended
surface cooking settings.
To Operate the Single Radiant Surface E_ements:
1, PUacecorrectUy sized cookware on the radiant surface
eUement,
Figure 1 Figure 2
Right Rear Element Center Rear Element
2.
3.
4.
Touch and hoUdthe pad for the desired eUement
position until a beep is heard. The dispUay will show " - "
Note: If no further pads are touched within 10 seconds the
request to power the element ON will clear.
Touch HI _ pad once to turn ON the power level to HI.
Touch Lo _ pad once for Lo (See Figure 5). The Hot
Surface indicator light will turn ON when the element becomes hot.
Each touch of the HI _'-Ab or Lo _v'_) pad will decrease or increase the power level
from 9.0 through 3.0 by .5 increments. Simmer power levels between 3.0 and 1.0 will
decrease or increase by .2 increments. Lo is the lowest power level available.
Note: The power level may be adjusted at any time while the element is ON.
Figure 3
Left Rear Element
When cooking has been completed touch the pad once to turn the element OFF.
Each surface element provides a constant amount of heat at each setting. A glowing red
surface heating area extending beyond the bottom edge of the cookware indicates the
cookware is too small for the surface heating area.
Note: The Hot Surface indicator light will remain ON if the cooktop is still hot and will
remain ON until the heating surface area has cooled sufficiently.
Radiant surface elements may appear to have cooled after they have been turned
off. The gtass surface may stilt be hot and burns may occur if the glass surface is touched
before it has cooled sufficiently.
Do not pJace pJastic items such as saJt and pepper shakers, spoon
hotders or plastic wrappings on top of the range when it is in use. These items could
melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the
surface elements.
Figure 4
Left Front Element
Figure 5
10
Loading ...
Loading ...
Loading ...