Kenmore 66572172301 gas range

User Manual - Page 23

For 66572172301.

PDF File Manual, 56 pages, Download pdf file

Loading ...
Loading ...
Loading ...
To Install Starter and/or Bulb:
1. Fit starter prongs into starter mounting base and turn
clockwise.
2. Slide bulb prongs into bulb mounting base ends. Roll the bulb
forward or backward 90 ° until it clicks.
3. Push down on the left end of the bulb mounting base. When
the assembly latches, it will click.
2. Pry door stop clip free and remove from front frame hinge
slot. Take care not to scratch finish.
3. Repeat procedure for other door stop clip.
To Remove:
1. Open the oven door. Insert door removal pins, included with
your range, into both hinge hangers. Do not remove the pins
while the door is removed from the range.
A. Removal pins
B. Hinge hanger
2. Slowly close the door until it rests against the door removal
pins.
3. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on the inside surface.
4. Pull door straight up, then toward you. Hinge hangers will
slide out of front frame hinge slot. Do not remove door
removal pins until the door is replaced on the range.
Replace lens cover. Position the 2 rear lens cover tabs in front
of the 2 metal spring clips (located directly behind the bulb).
Push back and down on the lens cover to lock into position.
_'z:_ _i_//ii iii iiiii i¸ -__
--_
5. Plug in range or reconnect power.
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then follow these instructions. The oven door is heavy.
Before Removing:
1. Use a putty knife or screwdriver and insert it at the bottom
corner of the door stop clip.
A
A. Doorstop clip
To Replace:
1. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on its inside surface.
2. Hold oven door so that the top edge of each hinge hanger is
horizontal. Insert hinge hangers into the front frame hinge
slots.
3. Tilt top of door toward range. Slide hinge hangers down onto
front frame support pins. Make sure the hinge hangers are
fully seated and engaged on the support pins.
A. Hinge hanger
B. Door frame hinge
C. Support pins
23
Loading ...
Loading ...
Loading ...