Loading ...
Loading ...
Loading ...
46. Wrap the Low Cable (75) around a 3 1/2" Pulley (24)
in the direction shown. Attach the Pulley and a Cable
Trap (25) to the indicated hole in the Press Upright (2)
with a 3/8" x 3 3/4" Bolt (59), a 3/8" Flat Washer (48),
and a 3/8" Nylon Jam nut (63). Make sure that the
Cable Trap is oriented as shown,
47. Route the Low Cable (75) under a 3 1/2" Pulley (24)
as shown. Attach the Pulley and a Cable Trap (25) to
the indicated hole in the Press Front Leg (20) with a
3/8" x 3 3/4" Bolt (59), a 3/8" Flat Washer (48), and a
3/8" Nylon Jam nut (63). Make sure that the Cable
Trap is oriented as shown.
47
25
48. Attach the closed loop at the end of the Low Cable
(75) to the indicated hole in the Leg Lever (41) with a
3/8" x 2 3/4" Bolt (46), two 3/8" Flat Washers (48) and
a 3/8" Nylon Locknut (50).
Go to step 24 and follow the instructions for tight-
ening the Cables.
49. Press two 1" x 2" Inner Caps (83) and a 1 1/4" Square
Inner Cap (82) into the Seat Adjustment Frame (90).
Insert a 1/4" x 1 1/2" Carriage Bolt (101) into the cen-
ter hole in a Seat Plate (65). Attach the Seat Plate to
one of the Seats (13) with two 1/4" x 3/4" Bolts (49).
Turn the Seat Adjustment Frame (90) so the holes in
the vertical tube are on the side shown. Insert the end
of the 1/4" x 1 1/2" Carriage Bolt (101) into the indicat-
ed hole in the Seat Adjustment Frame and secure it
with a 1/4" Flat Washer (71) and a 1/4" Nylon Locknut
(68). Attach the narrow end of the Seat (13) with a
1/4" x 1 1/2" Screw (103) and a 1/4" Flat Washer (71).
Pull the indicated Adjustment Handle (85) and insert
the vertical tube on the Seat Adjustment Frame (90)
into the indicated hole in the Butterfly Seat Frame (14).
Release the Adjustment Handle and let the tip snap
into one of the holes in the Seat Adjustment Frame.
2O
48
50
_/ 75
48 _
41
49
i/i
90
'_71
Holes in _---68
Vertical Tube L_y
_-_71
--lO3
j
1_:
14 i_
Hole \ .....
Loading ...
Loading ...
Loading ...