Loading ...
Loading ...
Loading ...
14. Hold the Press Seat Frame (7) between the Press
Front Leg (20) and the Press Upright (2) so that the
hole that is closest to the welded plate is facing the
Press Front Leg. Attach the Press Seat Frame to the
Press Front Leg with two 5/16" x 2 3/4" Bolts (89),
two 5/16" Washers (36), and two 5/16" Nylon
Locknuts (64). Do not tighten the Nylon Locknuts
yet.
Attach the Press Seat Frame (7) to the Press Upright
(2) with two 5/16" x 3 3/4" Bolts (66), two 5/16"
Washers (36), and two 5/16" Nylon Locknuts (64).
Tighten all Nylon Locknuts used in steps 13 and
14,
15. Attach a Bumper (40) to the indicated hole in the
Press Front Leg (20) with a #10 x 1" Screw (80).
Press a 2" Square Inner Cap (28) into each end of
the Leg Lever (41).
Lubricate the 3/8" x 3 1/4" Bolt (62). Attach the Leg
Lever (41) to the Press Front Leg (20) with the Bolt
and a 3/8" Nylon Locknut (50). Do not overtighten
the Nylon Locknut; it must be easy to pivot the
Leg Lever,
14
36
20
50
16. Press a 2" Square Inner Cap (28) into each end of
the Right Butterfly Arm (10). Wet the lower end of the
Right Butterfly Arm with soapy water• Slide a Butterfly
Foam Pad (29) onto the lower end of the Right
Butterfly Arm.
Lubricate the indicated axle on the Butterfly Upright
(1). Orient the Right Butterfly Arm (10) as shown and
slide it onto the axle. Secure the Butterfly Arm with
two Retainer Rings (31) and a 1" Round Outer Cap
(38) in the following way: Place the Retainer Rings
on top of the inverted Round Outer Cap, making
sure that the teeth on the Retainer Rings bend
towards the Round Outer Cap as shown in the
inset drawing. Gently tap the Round Outer Cap
onto the axle with a hammer,
Attach the Left Butterfly Arm (11, not shown) on the
opposite side by following the procedure described
above•
16
Lubricate
Axle
38
Axle
Teet3__
38J_ [_
10
Loading ...
Loading ...
Loading ...