Loading ...
Loading ...
Loading ...
INSTALLATIONINSTRUCTIONS
The collar houses the accumulator timer with actuating arm and
button.
The dryers are set for 60 minutes of drying. If you wish, you may
change to 30 or 45 minutes drying with the cams provided. See
"Replacing Nylon Timing Cams on Accumulator Mechanism"
section.
The coin-slide mechanism, control panel lock and key, and coin-
box lock and key are not included and are available from usual
industry sources.
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
9= Secure the coin slide mechanism from inside the control panel
using the 3/16" coin slide mounting rod included with slide
mechanism. Use 5/16" open-end wrench to tighten rod.
/
10. Install the coin box.
11. Repeat Steps 7, 8, 9 and 10 for the other coin-slide
mechanism.
12, For added security between the upper dryer and the collar,
insert the cotter hair pin through the connecting bolt.
1, Using two or more people, move dryer to desired installation
location.
2, Check that each leg is approximately 1" (2.5 cm) from base.
3, Wipe the interior of the drums thoroughly with a damp cloth.
4, Install coin vaults and locks (not supplied) into meter case
openings.
5, Install control panel lock and key (not supplied).
6, If you wish to change the 45-minute dryer timing cams to
either 30- or 60-minute timing cams, see "Replacing Nylon
Timing Cams on the Accumulator Mechanism" section.
Complete all of the steps given in that section before going to
Step 7.
7, Open control panel and rest it on the bottom edge of the
opening.
13, Close the control panel.
The tight fit of the coin box is set at the factory. Customer may
loosen fit as desired by loosening the slotted nuts.
O
8=
Control Panel
Insert the coin-slide mechanism through the opening to the
left of the control panel. You may have to loosen four
mounting screws for proper fit.
-_ Mounting Screws
10
Keep a record of all coin box key numbers. A lost key can only
be replaced if ordered by key number from Sears Parts. The
key number is located both on the key and behind the end
panel of the coin box. If the key number is not available, the
lock must be drilled out to remove the coin box.
Loading ...
Loading ...
Loading ...