Loading ...
Loading ...
Loading ...
Installation
*INSTALLATION*
74
Carefully remove the protective foil
from the supplied sealing strip.
Fix the sealing strip flush with the
front of the appliance on the door
opening side.
1. Position the sealing strip flush with
the lower edge of the top fixing
bracket.
2. Stick it down along its entire length.
If necessary, insert the locking pins
supplied for limiting the door opening
into the hinges from above (see “In-
stallation – Adjusting the hinges”).
Installing the wine conditioning unit
If the wine conditioning unit is
pushed too far into the niche, the
door will not close properly. This can
cause ice to build up, condensate to
accumulate and lead to faults in the
appliance. These can all lead to in-
creased energy consumption.
Push the wine conditioning unit into
the building-in niche, making sure a
gap of 42mm is maintained all round
between the appliance carcase and
the front of the housing unit side
walls.
Push the wine conditioning unit into
the niche until the fixing brackets at
the top and bottom touch the front
edge of the side walls of the housing
unit.
- With 16mm thick unit walls:
The spacers should touch the front
edge of the housing unit side walls at
the top and bottom.
- With 19mm thick unit walls:
The front edges of the top and bot-
tom hinges should be flush with the
front edge of the housing unit side
wall.
Check the position of the fixing
brackets at the top and bottom front
edge of the housing unit side wall
again.
Loading ...
Loading ...
Loading ...