Loading ...
Loading ...
Loading ...
Installation Instructions
[_ CONNECT AND RUN THE VALVE
DRAIN HOSE ICONT.i
• Elevating the drain hose mag cause back
pressure that could reduce the brine draw during
recharge. If raising the drain line overhead is
required to get to the drain point, measure the
inlet water pressure to the softener first. For inlet
pressures between 20 and 50 psi, do not raise
higher than 8' above the floor. For inlet pressure
above 50 psi, the drain line mag be raised to a
maximum height of 14'.
Fig. 4A Valve
drain
hose
! P /' ". g_I_
STANDPIPE
11½"air gap
FLOOR DRAIN
CONNECTING A RIGID VALVE DRAIN TUBE
To adapt a copper drain tube to the softener, bug a
compression fitting (1/4 NPT x 1/2" O.D. tube) and
needed tubing from gour local hardware store.
1/4" NPT
thread
Compression fitting
1/4 NPT x 1/2" O.D.
tube (not provided)
/
I
Cut barbs from valve
drain elbow (pull clip
and remove drain valve
elbow from valve)
1/2" outside
diameter copper
tube (not provided)
[6] INSTALL TIMER AND COVERS AND
MAKE HARNESS CONNECTION
_f] BRINE TUBING CONNECTION
• Route the brine tubing out of the largest hole in
the brine tank sidewall. Use the compression nut
(in parts bag) to connect tubing to the nozzle
assemblg at the main valve.
Compression nut Nozzle assembly
Brine tubing
assembly
Brine tank
J
I8] INSTALL THE BRINE TANK
OVERFLOW FITTINGS AND HOSE
• Insert the rubber grommet into the 3/4" diameter
hole in the brine tank sidewall as shown.
Push the end of the hose adapter elbow into the
grommet as shown.
Attach a length of hose (use remaining hose from
Step 5) to the hose adapter elbow. Use a hose
clamp to hold it in place.
Locate the other end of the hose at the drain
point. DO NOT ELEVATEthis hose higher than the
elbow on the brine tank.
IMPORTANT: DO NOT TEE OVERFLOW HOSE
TO VALVE DRAIN HOSE.
NOTE: This drain is for safetg onlg. If the cabinet
(brine tank) should
over-fill with water, Grommet
the excess is carried
to the drain.
Hose
adapter'_ Venturi
nozzle
Overflow
drain hose
Brine
tank
I -. ..... -÷
To sewer drain
See separate instructions included in box with parts.
8
Loading ...
Loading ...
Loading ...