Loading ...
Loading ...
Loading ...
Installation Instructions
PLAN HOW YOU WILL INSTALL THE
SOFTENER
You must first decide how to run in and out pipes
to the softener. Look at the house main water pipe
at the point where gou will connect the softener.
Is the pipe soldered copper, glued plastic or
threaded galvanized2 What is the pipe size2
kWARNING: Use onlg lead-free solder and
flux to prevent lead poisoning,
See Tgpicaf Installation Illustration. Use this as a guide
when planning gour particular installation. Be sure
to direct the incoming hard water supply to the
softener valve inlet fitting. The valve is marked
IN and OUT.
TYPICAL INSTALLATION ILLUSTRATION
O-rings (2)
J
Brine
tank
NOTE: See Drain
Hose Connections
section.
Fig. 1
CROSSOVER
Use if water supply flows
from the left. Include single
or 3-valve bypass.
water
From
softener t
outlet
Soft
water
To softener
inlet
OPTIONAL 3-VALVE BYPASS
INSTALLATION ILLUSTRATION
Soft water MAIN
Hard water
to outside
Pip E faucets
24V
transformer
120-volt
outlet
Inlet
valve
Hard
water
1" NPT male
pter (2)
_, O-rings (2)
INLET Clips (2)
Brine tank
Fig. 2
CROSSOVER
Use if water supply flows
from the left. Include single
or 3-valve bypass.
Hard
water (_ !:--::L-{2:::
From
softener t
outlet Z_
Soft
water
D
To softener
inlet
Loading ...
Loading ...
Loading ...