Loading ...
Loading ...
Loading ...
ge.com
Setting: Nodel Code, 12 or 24 Hour Clock and Gallons or Liters Measured
Model Code: The timer must have the right model code set to operate the water softening system
correctly. The correct code setting for the GNSM48F isA-39.
If FRZ_] is flashing in the display, do steps 3,4, 6 and 8 below.
To check for the correct code setting for your model, and to reset it ifneeded, do steps 1, 2, 3, 4, 6
and 8 below.
NOTE:The hour clock and water measure have factory-set default values. The defaults are:
12 or 24 hour clock -12; Gallons or liters measure - gallons.
12 or24 Hour Clock: With 12 hr set, alltime displays are in standard clock time ...12:06 AMto 1!:59
PM.If 24 hr isset,time displaysare in military time ...0!60 (!:00 AM)to 0660 (midnight).Tochange
from the 12 hr setting,do steps 1,2,4, B,6 and 8.
Gallons or Liters Measure:All water flow rate and usagedisplays are in gallonswith the default
setting. If resetto _, the same displaysare shown in liters.Usesteps 1,2,4, 6,7
and 8 to change.
[] Beginningfrom the presenttime display,pressand hold in the SETbutton until
(or as otherwise set)beginsto flash.
E_ pressand hold in the SETbutton again.
[_lf settingisother than A-39, usethe UPor DOWN button to set the correct numbeE
[] Pressthe SETbutton again and _ flashes.
[] Tochange the display to _ usethe UPbutton. Usethe DOWNbutton to resetto 12 hE
[] Pressthe SETbutton and _ flashes.
[] Usethe UPbutton to change to the _ setting. Usethe DOWN button to return to the
gallon setting.
r_l pressthe SETbutton a final time to return to the present time display.
21
Loading ...
Loading ...
Loading ...