Loading ...
Loading ...
Loading ...
Installation Instructions
[] CONNECT TO ELECTRICAL POWER
To gain access to the transformer/power cord
assemblg, remove the salt hole cover from the
softener. Unclip the tabs on the rear of the top cover
and rotate the cover upward to remove. DO NOT
PULL OR DISCONNECT WIRING.
• The softener works on 2/4volt-60Hz electric
power. The included transformer changes
standard !20-volt AC house power to 2/4volts.
Plug the transformer into a 120-volt outlet onlg.
Be sure the outlet is alwags live so it can not be
switched off bg mistake.
• Replace the top coven
Replace the salt hole cover.
PROGRAMMING THE CONTROL
PROGRAMMING THE CONTROL
or
Hold button
Up (+)
button
Set
button
Down (-)
_!i_::i' / button
Data
._ button
TIMER SETTINGS REQUIRED upon installation and
after an extended power outage.
NOTES:
• When the transformer is plugged into the
electrical outlet, 12:00 AM is flashing and the
words PRESENT TIME show in the upper displag
area. Program the timer as instructed below.
If,A--- is flashing, see the Setting Model Code
section.
• A beep sounds while pressing buttons for timer
programming. One beep signals a change in the
timer displag. Repeated beeps means the timer
will not accept a change from the button or arrow
gou have pressed and gou should use another.
• To program the timer, you will use the SET, UP (+)
and DOWN (-) buttons.
SET PRESENT TIME OF DAY
NOTE: If the words PRESENTTIME do not show in
the displag, press the SET button until they do.
1. Press the UP (+) or DOWN (4 button to set. The
UP button moves the displau ahead; the DOWN
button moves the time backward.
NOTE: Each pressofan uP or
DOWN buttonchanges the
time bU 1 minute.Holdingthe
buttonsinchanges the time
32 minutes each second.
I _,/'-I j--¢_
Ir"'UU
If the present time is between noon and midnight,
be sure PM shows.
If the present time is between midnight and noon,
be sure AM shows.
2. When the present time shows, press SET to applg.
10
Loading ...
Loading ...
Loading ...