Loading ...
Loading ...
Loading ...
a) Loosen the screw and move the rail bracket
forward or rearward on the rail.
b) Tighten the screw.
2. Put a strap through the hole in the rail bracket (A).
B
A
3. Put the strap through the rail bracket (B) on the
opposite side.
4. Use the rail brackets to attach the load with straps.
CAUTION: Do not overload the
rails. Refer to
Technical data on page
115
.
Maintenance
Introduction
WARNING: Before you do any
maintenance work you must read and
understand the safety chapter.
Maintenance schedule
* = The instructions are not given in this operator's
manual.
X = The instructions are given in this operator's manual.
Note: If there is more than 1 time interval for a task,
the shortest time interval is for the first maintenance.
After the first maintenance, obey the longer time interval.
Maintenance schedule
1. PREPARE THE PRODUCT First
servicing
Maintenance interval
in hours
50 100 200
Do a check of the battery. O
Do a check of the blades. O
Do a check of and clean hydraulic hoses and couplings. Replace if necessary. O
Do a check of the belts and pulleys. O O
Do a check of the steering chain of the inner side of the frame tunnel. O
Do an inspection, lubricate and adjust all wires. O
Make sure that the tire pressure is correct. Refer to
Tire pressure on page 104
. O O
Make sure that all screws and nuts are tightened with the correct torque. O
Lubricate the operators seat. O
Lubricate all chains. O
Lubricate the wheels and blade bearings on the cutting deck. O O
98 838 - 010 - 15.03.2022
Loading ...
Loading ...
Loading ...