Loading ...
Loading ...
Loading ...
3. TRANSMISSION, CONTROLS AND DRIVE SYSTEM First
servicing
Maintenance interval
in hours
50 100 200
Do a check of the oil in the transmission and fill if it is necessary. Refer to
To do
a check of the transmission oil level on page 109
.
O
Examine and adjust the parking brake. O O
Replace the oil in the transmission. Refer to
To do a check of the transmission
oil level on page 109
.
O O
4. CUTTING EQUIPMENT First
servicing
Maintenance interval
in hours
50 100 200
Clean the outer and inner surfaces of the cutting deck and the cutting deck
covers.
O O
Do a check of and adjust the cutting height and pitch setting. O O
Examine the blades in the cutting deck, sharp and balance if needed. O
5. LAST INSPECTION AND DOCUMENTATION First
servicing
Maintenance interval
in hours
50 100 200
Do a check of and adjust the engine RPM. O O
Make sure that the product does not move in neutral position. O O
Do a check of the forward drive and the rearward drive on different speeds. O O
Do a check of the blade engagement, seat, lift and forward drive/brake. Refer to
Safety devices on the product on page 90
.
O O
Do an inspection of the collection system (if applicable). O O
To clean the product
CAUTION: Do not use a high-pressure
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which causes damage to
the product.
Clean the product immediately after use.
• Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
• Before you clean with water, clean with a brush.
Remove grass cuttings and dirt on and around the
transmission, the transmission air intake, and the
engine.
• Use running water from a hose to clean the product.
Do not use high pressure.
• Do not point the water at electrical components or
bearings. Detergent usually increases the damage.
• To clean the cutting deck, put it in the servicing
position and clean it with a water hose.
100 838 - 010 - 15.03.2022
Loading ...
Loading ...
Loading ...