Loading ...
Loading ...
Loading ...
USER MANUALPG 23
INSTALLING COOKER -
POWER CONNECTIONS
FITTING A POWER SUPPLY CABLE
WARNING: Installation MUST ONLY be carried out by a qualified approved installer, ie. an Electrician.
Connecting appropriate power supply ` terminal board/ connector block:
NOTE: REFER to TECHNICAL tables at the rear of this manual for correct rating for your corresponding
model purchased.
• Using a screwdriver, prize open tabs of the Terminal board cover.
• Remove the wire clamp screw.
• Fasten the wires beneath the corresponding screw heads, using brass ‘bridge’ for single phase supply.
• Fasten cable clamp and close the cover of the terminal board.
• The AC power supply should be 220-240V, 50-60Hz.
WARNING: Connect the power cord must be in accordance with the instructions listed in the table below
Connecting the supply cable to the mains
Install an approved circuit breaker with a minimum contact opening of 3 mm, between the appliance
and the mains fuse box. The circuit breaker should be sized according to the load and should comply with
current regulations (the earth wire should not be interrupted by the circuit breaker).
The supply cable should be positioned so that it does not reach a temperature of more than 50ºC with
respect to the room temperature, anywhere along its length Before switching fuse ON in meter-box check:
• Earth continuity. The electrical safety of this appliance can only be guaranteed if the cooker is correctly
installed and earthed, in compliance with regulations on electrical installations.
• The electrical capacity of the system and sockets will support the maximum power of the appliance, as
indicated on the data plate
• Go to section 19 “Installing your new cooker”
NOTE: All Upright cookers must comply to local regulations to Australian Standard AS/NZS 3000:2007
guidelines. Qualified Electrician will have a copy of these guides that MUST be adhered to.
Loading ...
Loading ...
Loading ...